Curves Control points

Reported bugs that have been closed and/or resolved

Moderators: XnTriq, xnview, Dreamer

Post Reply
vicsharx
Posts: 69
Joined: Thu Feb 25, 2016 2:04 pm

Curves Control points

Post by vicsharx » Mon Dec 31, 2018 12:01 pm

It is quite difficult to move a pre existing point control in the curves editor as unless you click exactly in the point it will create a new one. As as result most of the times we try to move a point we create a new one instead very near to the old one.
The logical behaviour is to allow a invisible interactive wider circle around the point where it will move the point instead create a new one. This won't create problems as it is unlikely anyone one wants intentionally create a point very near to a old one but rather move the old one. Points that are very near create bad curves. This would help to guess what the use wants.

User avatar
xnview
Author of XnView
Posts: 31178
Joined: Mon Oct 13, 2003 7:31 am
Location: France
Contact:

Re: Curves Control points

Post by xnview » Thu Jan 03, 2019 2:23 pm

yes the sensitive area is too small issue
Pierre.

User avatar
xnview
Author of XnView
Posts: 31178
Joined: Mon Oct 13, 2003 7:31 am
Location: France
Contact:

Re: Curves Control points

Post by xnview » Thu Jan 31, 2019 1:49 pm

This problem is supposed to be fixed in XnView MP 0.93. Please check and confirm the bug fix here.
Pierre.

Post Reply