Page 1 of 1

Curves Control points

Posted: Mon Dec 31, 2018 12:01 pm
by vicsharx
It is quite difficult to move a pre existing point control in the curves editor as unless you click exactly in the point it will create a new one. As as result most of the times we try to move a point we create a new one instead very near to the old one.
The logical behaviour is to allow a invisible interactive wider circle around the point where it will move the point instead create a new one. This won't create problems as it is unlikely anyone one wants intentionally create a point very near to a old one but rather move the old one. Points that are very near create bad curves. This would help to guess what the use wants.

Re: Curves Control points

Posted: Thu Jan 03, 2019 2:23 pm
by xnview
yes the sensitive area is too small issue

Re: Curves Control points

Posted: Thu Jan 31, 2019 1:49 pm
by xnview
This problem is supposed to be fixed in XnView MP 0.93. Please check and confirm the bug fix here.