Page 1 of 1

fit window to image...

Posted: Tue Jan 16, 2007 4:43 pm
by Koogle
ok still think this should be better..

view mode: Auto Image Size: Fit image to desktop, large only

example: I open an image up but this image happens to be really long in height so because of the settings its proportionaly resized the image to fit onto my desktop size.. but I can't see anything its so small.. and the width is small so.. i press '*' to get the 100%, now it would be great if i could then press [ctrl]+[t] and have XnView increase the width of the window to now fit the image again.. its already maximised the height value, so it should increse the width as much needed to fit the image, or until it reaches the maximum desktop width(based on the monitor it is currently displayed on.. not the total number of multiple desktop monitors unless thats an option)...

is this not possible? Isn't Ctrl+T not meant to "Fit Window to Image" because its not working this example.. and it would be great if it did.

really would like to find a solution to this before the final release please :)

V 1.90 RC2

Posted: Sat Jan 20, 2007 3:58 pm
by Koogle
so will there be a solution to this? yay nay?

Posted: Sun Jan 21, 2007 10:18 pm
by helmut
Sorry for not replying, but I think it needs a specialist for all those "Fit image to" options...

Posted: Mon Jan 22, 2007 5:53 pm
by Olivier_G
You know where I stand...
I will push this one for version just after 1.90.