0.56 - W8/x64: Batch convert - crop preview is wrong
Posted: Sun Jun 16, 2013 8:39 am
I created a series of screenshots (full screen, Winkey-PrtScn) that obviously needed te be cropped afterwards.
The following problem occurs in XnViewMP 0.56 (on W8/x64).
I select the images
I start the function "Batch Convert"
I select the action "Crop"
Initially the crop preview on the right shows the full picture in its right size
After I have applied some top, left, right, or bottom crop values, the crop preview does NOT exactly match the result of the values I just entered.
The crop preview makes you think that more is cropped than would correspond to the values entered.
In short: If you enter crop values by using the crop preview, you will end up with images that are still too large.
If on the other hand you opened the image in another application and determined the applicable crop values there (with a bit of calculation), then applying these values in XnViewMP - Batch convert - crop will work perfectly. So the cropping in itself is fine, it's the crop preview that appears to be off.
Stephan
The following problem occurs in XnViewMP 0.56 (on W8/x64).
I select the images
I start the function "Batch Convert"
I select the action "Crop"
Initially the crop preview on the right shows the full picture in its right size
After I have applied some top, left, right, or bottom crop values, the crop preview does NOT exactly match the result of the values I just entered.
The crop preview makes you think that more is cropped than would correspond to the values entered.
In short: If you enter crop values by using the crop preview, you will end up with images that are still too large.
If on the other hand you opened the image in another application and determined the applicable crop values there (with a bit of calculation), then applying these values in XnViewMP - Batch convert - crop will work perfectly. So the cropping in itself is fine, it's the crop preview that appears to be off.
Stephan