Toolbars - how to synchronize viewer with browser toolbar?

Ask for help and post your question on how to use XnView MP.

Moderators: XnTriq, helmut, xnview

Post Reply
mrwul
Posts: 327
Joined: Tue May 25, 2010 7:01 pm

Toolbars - how to synchronize viewer with browser toolbar?

Post by mrwul »

There is a difference between the toolbar after double clicking an image file (viewer toolbar?)
and the one showing up when 'browsing' (say, the Explorer like toolbar).

Is there an easy way to synchronize these toolbars, or better said, to have the browser toolbar be the same as the 'viewer-toolbar'?

Thanks!

=
SnagIt-01032017 071634.png
=
Erixx haxx
Posts: 330
Joined: Tue Jul 28, 2015 10:37 am

Re: Toolbars - how to synchronize viewer with browser toolba

Post by Erixx haxx »

Hello:

Options>> Interface>>Toolbar
Lets you add and remove the command buttons.. I'm not sure if both have the same options though.
mrwul
Posts: 327
Joined: Tue May 25, 2010 7:01 pm

Re: Toolbars - how to synchronize viewer with browser toolba

Post by mrwul »

Thanks. I know.
Rightclick toolbar -> Customize is the same.
I was hoping on a kind of 'copy over' from viewer to browser so to say.
Seems, right now, one has to configure them separately.
Not a big problem, but would have been easier to configure 1 and then something like
'set same toolbar for browser'
or something like that

Anyway, thanks again.
=
cday
XnThusiast
Posts: 3976
Joined: Sun Apr 29, 2012 9:45 am
Location: Cheltenham, U.K.

Re: Toolbars - how to synchronize viewer with browser toolba

Post by cday »

mrwul wrote:Seems, right now, one has to configure them separately.
Not a big problem, but would have been easier to configure 1 and then something like
'set same toolbar for browser' or something like that.
But some functions are only applicable for one mode or the other, so it is only possible to synchronise them to an extent...
tboy
Posts: 99
Joined: Wed Jan 26, 2005 11:44 pm

Re: Toolbars - how to synchronize viewer with browser toolba

Post by tboy »

Go to Cusstomize toolbar and click Save button on upper right position.
Save as 'My1' for example.
Open xnViewMP directory, file 'My1.bar' will be there, open it with notepad.
You will see sections for Browse and View.
Edit as you like and save (with xnVew not running). Example - Copy all between Browse and View rows, delete everything after View and paste there.
Start xnView and you must see new toolbars, if not - open again 'customize toolbar' and click on LOAD , then select 'My1.bar'.

Don't do this if you don't know how to restore initial state in case of errors.
Post Reply