XnView Software

Posted: **Mon Apr 28, 2008 6:44 pm**

BabaG wrote:my sense (from a non-programmer's point of view, of course), is that something like an auto-correction already exists, such as what is being used in xnview's thumbnail preview frame, and that possibly some code was copied from one place to another that included a call to that routine or function. if that was the case, it would only need to be found and commented out.

Yes, you may be right. I guess it's like this:
Now, auto correction is ON by default. In future, it will be OFF by default and an option is available for turning it ON.

Posted: **Tue Apr 29, 2008 5:46 pm**

that would be even better than commenting it out.
hope this arrives soon!

thanks,
BabaG

Posted: **Tue May 06, 2008 7:55 pm**

been another week. thought i'd check in.

any progress on getting an nconvert patch or something for this
issue?

thanks,
BabaG

Posted: **Wed May 07, 2008 8:20 am**

You have an option in the 4.95 release

Posted: **Wed May 07, 2008 4:54 pm**

thanks pierre!

two things: is usage of the new option documented anywhere?
edit: found this.

and, when will that be available for linux?

thanks again,
BabaG

XnView Software

Still cr2 problems with unwanted auto correcting