Various discussion boards for XnView and related products
https://newsgroup.xnview.com/
Code: Select all
Zoom
Fit to...
(*) Window
Window Height
Window Width
Condition
(*) All Images
Small images only
Large Images only
The present 'No fit' option would need to be added as another 'Fit to...' option?xnview wrote:hum, it's clean but 2 radiobuttons to set it
Remember that we don't change both radiobuttons every hour. In fact I don't think that we change any radiobutton every hour...hum, it's clean but 2 radiobuttons to set it
Well yes, but having just one list for a cartesian product (that is, all combinations of two dimensions/factors: Fit to... and How to fit...) can be quite confusing to write in just one list.The idea was to provide additional viewing options, but any new options that are needed could in principle be added to the existing vertical list, and it would be natural to run the eye down the expanded list to select the required option...
And then there would be three possible 'No fit' Condition options available?cday wrote:The present 'No fit' option would need to be added as another 'Fit to...' option?
Speaking now as a programmer rather than an user, I would choose the 'No fit'/uncovered cases to be just 100% (unscaled)cday wrote:And then there would be three possible 'No fit' Condition options available?cday wrote:The present 'No fit' option would need to be added as another 'Fit to...' option?
And if 'Large Images only' were selected, the fit for other images be not be defined?
xnview wrote:everyone is agree with this change?XnTriq wrote:
- Fit image to »
- No fit
————————————
Window
Window, large only
Window, small only
Window width
Window height
Window width or height
Everyone agrees...m.Th. wrote:Generally I agree...
