Page 1 of 1
Crash in Batch Convert dialog
Posted: Mon Jun 18, 2007 11:37 pm
by aguirRe
When using XnView 1.91.1 on top of WinXP, I've on two occasions got a crash in the Batch Convert Dialog when adjusting Sharpen value in the Transformations tab. In this case the Sharpen item was at the end of the active list and I was just clicking on the left/right arrow buttons.
DrWatson reported an access violation on EIP 0x4ffef8.
Posted: Tue Jun 19, 2007 1:12 am
by ckit
I can re-produce the crash but only after using the up and down arrows as well in that dialog?
Posted: Tue Jun 19, 2007 9:13 am
by aguirRe
Yes, I did that too to re-arrange filter order before.
I've also had a lot of problems making the settings stick in this dialog. Sometimes after changing a value on one item and switching with the mouse to another item and then back again, the value is restored so I have to change it again.
Especially the Resize item has this issue, but others as well
Posted: Tue Jun 19, 2007 7:34 pm
by xnview
Do you have an easy way to reproduce it always?
Posted: Tue Jun 19, 2007 10:16 pm
by aguirRe
No, but it happens pretty frequently, so it should be easy to reproduce. Otherwise you have the EIP above and I can also send you the DrWatson crash info if you need it.
Posted: Wed Jun 20, 2007 8:18 pm
by xnview
aguirRe wrote:No, but it happens pretty frequently, so it should be easy to reproduce. Otherwise you have the EIP above and I can also send you the DrWatson crash info if you need it.
Ok, i have perhaps found the problem, could you send me your email by PM (i would like to send a test version?)