Page 1 of 1
Installation of 1.93 (final) fails while register DLL/OCX
Posted: Fri Mar 14, 2008 7:15 am
by Bobf
Hi team,
i have updated my xnview 1.92.1 today with the 1.93 (final).
The installations fails with the error:
-------------------------------------------------------------------------------------
C:\program files\Xnview\ShellEx\XnViewShellExt.lng
Unable to register the DLL/OCX:RegSvr32 failed with exit code 0x3
[Abort] [Retry] [Ignore]
-------------------------------------------------------------------------------------
System is a W2k SP2....
All Xnview plugins selected ....
rgs Bob
Re: Installation of 1.93 (final) fails while register DLL/OC
Posted: Fri Mar 14, 2008 8:07 am
by xnview
Bobf wrote:Hi team,
i have updated my xnview 1.92.1 today with the 1.93 (final).
The installations fails with the error:
-------------------------------------------------------------------------------------
C:\program files\Xnview\ShellEx\XnViewShellExt.lng
Unable to register the DLL/OCX:RegSvr32 failed with exit code 0x3
[Abort] [Retry] [Ignore]
-------------------------------------------------------------------------------------
System is a W2k SP2....
All Xnview plugins selected ....
rgs Bob
Ok, an error in the setup
Re: Installation of 1.93 (final) fails while register DLL/OC
Posted: Fri Mar 14, 2008 7:40 pm
by reiba
Bobf wrote:Hi team,
i have updated my xnview 1.92.1 today with the 1.93 (final).
The installations fails with the error:
-------------------------------------------------------------------------------------
C:\program files\Xnview\ShellEx\XnViewShellExt.lng
Unable to register the DLL/OCX:RegSvr32 failed with exit code 0x3
[Abort] [Retry] [Ignore]
-------------------------------------------------------------------------------------
System is a W2k SP2....
All Xnview plugins selected ....
rgs Bob
I had the same mistake yesterday on three different Computers. But since xnview 1.93.1 the mistake is gone (after downloading this morning). No problems at all.
Re: Installation of 1.93 (final) fails while register DLL/OC
Posted: Fri Mar 14, 2008 8:36 pm
by helmut
reiba wrote:... But since xnview 1.93.1 the mistake is gone (after download this morning). No problems at all.
Good to read, thanks for letting us know, reiba!
Grüße in die Schweiz!
Posted: Fri Mar 14, 2008 10:02 pm
by reiba
Danke!
But I don't understand, why it still says version 1.93 on the download-Site. In Fact: Loading down and installing xnview it says that it is 1.93.1. – a bit irritating, but no problem
))