XnView Software

Pierre

Hello !

• In the Browser >> View Menu >> Preview pane :

- If you untick the “Preview” item, then it remains greyed out, it's impossible to reset it.
- That remains such as even when restarting the programme, the “Preview” panel is no longer available…
- Except to rummage in the registry, is there a way to restore that panel ?

KR
Claude
Clo

I don't understand, you have tree pane/show

—> Pierre

Again,

• I'm talking of the PREVIEW panel, not the tree !
EDIT :

• Finally, I found the solution, since we have to activate the Show entry
which is not in the same section of the sub-menu,
but under the separator ! Why is that entry set in addition? It's totally illogical and confusing.
- In the usual XnView Win versions, the options to tick in the menus are directly bistable;
when disabled, just re_tick the item, there is no need to click another separate entry…

KR
Claude
Clo

Clo wrote: • I'm talking of the PREVIEW panel, not the tree !

Sorry it's in 'Preview Pane' like xnview win

Pierre

Hello !

• Well, but like I said above, in the 1.9x versions, there is no extra "Show" entry to reset the items "ON" !
And moreover, in the MP this Show entry is outside the section, it's pretty unclear…
- Isn't it possible to have the same, let's say : Just tick¦untick the menus items, like in the 1.9x versions ?

KR
Claude
Clo

Clo wrote: • Well, but like I said above, in the 1.9x versions, there is no extra "Show" entry to reset the items "ON" !
And moreover, in the MP this Show entry is outside the section, it's pretty unclear…

You have the same menu & behaviour in xnview win!

Pierre

Hello !

• In the Win versions, there is a mismatch between the English and French wordings there,
I'll show that in the French forum.
- Anyway, I don't see why that "Show" entry is needed…

KR
Claude
Clo

Clo wrote: - Anyway, I don't see why that "Show" entry is needed…

Show allow to show or hide the preview pane