XnView Software

This is a weird occurance I doubt anyone will recreate. This is certainly not how Xnview is meant to be used. I was comparing speed differences between fullscreen modes with the Quickshow delay set to "0", lowest quality settings. Each mode went through 800files/59Megs in 60 seconds. No cache was used. QuickSlideShow set to stop when in reached the end. **In the new fullscreen mode, I pressed <home> when it hit the end. The QuickShow then ran backwards to the start instead of just skipping immediately to first photo. It worked correctly in 2 other attempts.

---
Edit1: It runs backwards with normal use too, when pressing <home>.
This seems to only happen in PreviewFullscreen mode.
---

marsh wrote:This is a weird occurance I doubt anyone will recreate. This is certainly not how Xnview is meant to be used. I was comparing speed differences between fullscreen modes with the Quickshow delay set to "0", lowest quality settings. Each mode went through 800files/59Megs in 60 seconds. No cache was used. QuickSlideShow set to stop when in reached the end. **In the new fullscreen mode, I pressed <home> when it hit the end. The QuickShow then ran backwards to the start instead of just skipping immediately to first photo. It worked correctly in 2 other attempts.

---
Edit1: It runs backwards with normal use too, when pressing <home>.
This seems to only happen in PreviewFullscreen mode.
---

Strange, i can't reproduce it...

I cannot recreate this in new installs of RC4 or RC3. When the other problems are resolved, I'm fairly certain this will not happen again.

Fixed.