Page 1 of 1
RC4: "Move" cursor not reset to standard cursor
Posted: Thu Jun 02, 2005 7:55 pm
by helmut
When selecting an area, and then moving inside the selected area and pressing Ctrl key, the mouse cursor changes and indicates that selection can be moved. This is good, but when releasing Ctrl key, the mouse cursor is not reset. (Minor issue).
Posted: Thu Jun 02, 2005 11:14 pm
by Olive
yes, need to move the mouse to reset it.
though it's properly reset if LMB is set to move selection (in options>keyboard/mouse)
Posted: Fri Jun 03, 2005 2:21 pm
by Dreamer
Confirmed.
Posted: Mon Jun 13, 2005 10:46 am
by ckit
Confirmed in RC6 - minor issue until you move the mouse.
Posted: Mon Jun 13, 2005 10:57 am
by Hacker
ckit wrote:Confirmed in RC6 - minor issue until you move the mouse.
? The cursor isn't shown after moving the mouse, either.
1. Open file in View
2. Go to normal Fullscreen
3. Wait for cursor to disappear
4. Press F12 and try to click something.
Roman
Posted: Mon Jun 13, 2005 11:00 am
by ckit
Hacker wrote:
? The cursor isn't shown after moving the mouse, either.
1. Open file in View
2. Go to normal Fullscreen
3. Wait for cursor to disappear
4. Press F12 and try to click something.
Roman
This has been fixed in RC7.
Re: RC4: "Move" cursor not reset to standard curso
Posted: Tue Jun 14, 2005 6:40 am
by ckit
helmut wrote:When selecting an area, and then moving inside the selected area and pressing Ctrl key, the mouse cursor changes and indicates that selection can be moved. This is good, but when releasing Ctrl key, the mouse cursor is not reset. (Minor issue).
This is still a minor issue in RC7.