XnView Software

hi,

There is a strange but hard to reproduce bug in MP 0.48 in where the Next/Prev stops working after either doing some action or XnViewMP coming out of idle to use.

I am still trying to figure out a good reproduction for this bug,,,,The last time it occurred was very recently in where I had a folder of about 200 image files and I did an overwrite 'Save' on one image file in the same folder and then then the Next/Prev suddenly stopped working.

The Next/Prev is still in use and not greyed-out but just gets unresponsive.

I will do my best to figure out a good reproduction to post here.

Right,

Here's one:


1.) Have a folder with about 100 image files or more
2.) Open just 1 image file into view mode (XnView MP 0.48) from this same folder
3.) Press "Next" or "Prev"...It works as normal
4.) Now duplicate the tab and close original tab opened
5.) Press "Next" or "Prev"...It works as normal
6.) Now add 2 or more new files to this folder through Win Explorer
7.) Now "Next" or "Prev"...And now the "Next" or "Prev"is not responding

..It is not responding due to folder file-list change (I think!) so this could be investigated

Do you use option>Filelist - New files at the end...?

xnview wrote:Do you use option>Filelist - New files at the end...?

No, I have this disabled

Right...So you reckon you just need to fix this new setting to add support for it if not used correct?

Thank you. Fixed in XnViewMP 0.50