XnView Software

Just installed v0.69

- By default there is no configured buttons for next/prev picture.
- When i set it to left and right arrows is only works in fullscreen mode. But NOT ALWAYS! It works 2-3 times and... nothing till i open settings again. Settings is not erased, but arrows not working if i not redefine it again...

- When i tried to press arrows many times when its "off", program closes with error

Please use Settings>Interface>Keyboard and restart XnViewMP

Of course, many times. After restart buttons is not working again.
Now it's fully not working pgUp/pgDn is working at any case, but i'm not always use external keyboard

sashabeep wrote:Of course, many times. After restart buttons is not working again

but in screenshot, you don't use Keyboard tab but shortcuts...

It's very hard to find the difference between hotkeys and keyboard settings without your explanation. Now all is OK

sashabeep wrote:It's very hard to find the difference between hotkeys and keyboard settings without your explanation. Now all is OK

Arrows are a special case...

OK, space/backspace is also special case???

sashabeep wrote:OK, space/backspace is also special case???

backspace is used to go on parent folder