Draw tool - Constrain line angle with Shift
Posted: Tue May 16, 2017 11:51 am
The Draw tool was a very welcome addition to XnView MP 
. But just one more request please:
In drawing programs, there is a convention when drawing a line that holding down the Shift key constrains the angle drawn to multiples of some angle value, typically 0 45 90 or 0 30 60 90 ...
That option would be a very useful addition, even if the angles drawn were constrained to horizontal or vertical initially...
. But just one more request please:In drawing programs, there is a convention when drawing a line that holding down the Shift key constrains the angle drawn to multiples of some angle value, typically 0 45 90 or 0 30 60 90 ...
That option would be a very useful addition, even if the angles drawn were constrained to horizontal or vertical initially...