Page 1 of 1
"Invert" selection option
Posted: Fri Oct 07, 2005 5:59 pm
by klumy
an option to invert the rectangle selection would be great
Re: "Invert" selection option
Posted: Sat Oct 08, 2005 10:39 am
by xnview
klumy wrote:an option to invert the rectangle selection would be great
Why, you can only make rectangle for selection?
Posted: Sat Oct 08, 2005 11:04 am
by klumy
I am looking for an INVERT option
so I can select the area OUTSIDE from the rectangle
Posted: Sat Oct 08, 2005 10:06 pm
by helmut
klumy wrote:I am looking for an INVERT option
so I can select the area OUTSIDE from the rectangle
At the moment, XnView supports only rectangular selections. This is why you cannot invert selections in XnView (inverting a rectangle makes a rectangle with a whole in it).