XnView Software

Hi,

1. Is it possible to have an image go full screen when double-clicking it in the browser?

2. I'm using a dual monitor configuration. F11 is setup to send the image full screen on the secondary monitor which is also calibrated and has its own ICC profile. So, since I can configure only one ICC profile, what profile is used when displaying the image on the secondary display ?

Thanks in advance.

Samoreen wrote:
1. Is it possible to have an image go full screen when double-clicking it in the browser?

Please check Settings>Inteerface>Switching mode

2. I'm using a dual monitor configuration. F11 is setup to send the image full screen on the secondary monitor which is also calibrated and has its own ICC profile. So, since I can configure only one ICC profile, what profile is used when displaying the image on the secondary display ?

currently it's the same