XnView Software

Hi,

if I use a network printer to print an image (jpg) my windows 10 (pro 64-bit) computer (always) reboot itself.
With Windows 7 and the same printer I did'nt have any problems. Also with the printer installed locally, there are no problems.
I've tried XnViewMP now and there are no crashes. Is this a known bug? To solve my problem I'm now using XnViewMP, but perhaps it's good to know for you.

Thx for this tool

Same bug with Kyocera network printer (wide range of models: FS-1035MFP, Ecosys M2540DN and overs)
xnview classic 2.45 - 2.48

It happens if are activated checkboxes:
Print -> Caption -> Show information
or
Print -> Header/Footer -> any of them

BSoD information attached there .

PC goes to BSoD, printer - print next info:

Hi! I really don't understand why people can't understand that HP make the worst printers in the world. There are 2 options. Either I'm so unlucky, or they make really terrible office equipment that gives a permanent failure. I also had problems with the printer, and even when I was choosing a printer for home, I was faced with the fact that there are very few high-quality models, and most of them are only well advertised. I found the only reliable models on https://www.mrdepot.ca/products/samsung ... 85fw-toner and I'm very glad I came across them.

Alex_02366 wrote: Wed Mar 13, 2019 5:26 pm It happens if are activated checkboxes:
Print -> Caption -> Show information
or
Print -> Header/Footer -> any of them

if these options are not enabled, no crash?