Curves Control points
Posted: Mon Dec 31, 2018 12:01 pm
It is quite difficult to move a pre existing point control in the curves editor as unless you click exactly in the point it will create a new one. As as result most of the times we try to move a point we create a new one instead very near to the old one.
The logical behaviour is to allow a invisible interactive wider circle around the point where it will move the point instead create a new one. This won't create problems as it is unlikely anyone one wants intentionally create a point very near to a old one but rather move the old one. Points that are very near create bad curves. This would help to guess what the use wants.
The logical behaviour is to allow a invisible interactive wider circle around the point where it will move the point instead create a new one. This won't create problems as it is unlikely anyone one wants intentionally create a point very near to a old one but rather move the old one. Points that are very near create bad curves. This would help to guess what the use wants.