XnView Software

I just downloaded Xnview MP. I am using it to view .dcm medical images. I need a way to accurately pan around these images in View Mode. I am aware of the small icon in the lower right of the View mode for panning, but it is not accurate enough. The up-arrow/down-arrow work fine for for up/down panning, but the left/right arrow move to the next/previous image. I would like to change left/right arrows to pan left/right, but I couldn't find a command for this. Also, I couldn't find any left/right/up/down settings in the shortcut menu. Is there a way that I can change the left/right arrow shortcut to do left/right panning, or is it hardwired to next/previous image?
Note: I would like to use Page Up/Down to move to next/previous image.

Please take a look at the available options in Tools > Settings... > Interface --Mouse tab and --Keyboard tab.

Also, please post XnView MP future support requests in the XnView MP section of the forum!

cday
Thank you very much. That fixed my problem!!!! Sure didn't think to look there. I was too intent on Shortcuts.
Thanks again,
ralphl