XnView Software

Posted: **Sun Dec 11, 2005 6:36 pm**

In the new batch rename> duplicate... dialog, the data sets for numbers/characters radio buttons are reversed. Characters are using numbers data. Numbers are using chararcters data.

Posted: **Sun Dec 11, 2005 6:43 pm**

marsh wrote:In the new batch rename> duplicate... dialog, the data sets for numbers/characters radio buttons are reversed. Characters are using numbers data. Numbers are using chararcters data.

Well spotted - I confirm.

Posted: **Mon Dec 12, 2005 7:49 am**

helmut wrote:
marsh wrote:In the new batch rename> duplicate... dialog, the data sets for numbers/characters radio buttons are reversed. Characters are using numbers data. Numbers are using chararcters data.
Well spotted - I confirm.

Confirmed

Posted: **Tue Dec 20, 2005 1:08 am**

Fixed in beta2

Posted: **Tue Dec 20, 2005 8:49 am**

Let me ask again- and what is this Duplicate option going to do? I played with it a bit and cannot figure it out...

X.

Posted: **Tue Dec 20, 2005 9:30 am**

Xyzzy wrote:Let me ask again- and what is this Duplicate option going to do? I played with it a bit and cannot figure it out...

X.

If a duplicate name is produced when using main template, this dialog decides what to do with that by using a second template. It also adds the capacity of using alphabet characters instead of numbers. There is a topic about this in alpha section, also.

XnView Software

b1: 'Replace # by' wrong data used.

b1: 'Replace # by' wrong data used.

Re: b1: 'Replace # by' wrong data used.

Re: b1: 'Replace # by' wrong data used.