XnView Software

1. If I select many pictures and edit the iptc data with "write all selected" I get no information when the process is finished. If I click too early on the cancel button I get the message that XnView is in process. I would suggest to show the hourglass cursor while operating.

2. The caption "cancel" is a little confusing. Usually it is used if no changes should be applied. "Close" would be more neutral.

3. I it possible to add the ability to change the order of the IPTC keywords?

XnView 1.82 <x>

Anika wrote:1. If I select many pictures and edit the iptc data with "write all selected" I get no information when the process is finished. If I click too early on the cancel button I get the message that XnView is in process. I would suggest to show the hourglass cursor while operating.

2. The caption "cancel" is a little confusing. Usually it is used if no changes should be applied. "Close" would be more neutral.

Ok

3. I it possible to add the ability to change the order of the IPTC keywords?

I'll add in my TODO list

It seems so far only changed Cancel to Close.

X.

OK, so in rc1 we have Close and hourglass.

There is still no possiblity to arrange keywords. Moving to New.

X.

Xyzzy wrote:OK, so in rc1 we have Close and hourglass.

There is still no possiblity to arrange keywords. Moving to New.

Not for this release