Page 1 of 1
b2: Rotate dialog: slider position
Posted: Mon Dec 19, 2005 10:57 pm
by Xyzzy
<Moderator's note: This topic has been split from another topic>
Value is immediately updated now, but there is another problem, with slider position update. To reproduce:
Drag slider far left. Click the slider-line below the value field with mouse a few times. Slider is jumping around, and should move to mouse pointer position at first click and stay there for subsequent clicks.
X.
XnView 1.82 <x>
Re: b2: Rotate dialog: slider position position
Posted: Mon Dec 19, 2005 11:18 pm
by helmut
Xyzzy wrote:... Slider is jumping around, and should move to mouse pointer position at first click and stay there for subsequent clicks.
X.
I confirm.
Re: b2: Rotate dialog: slider position position
Posted: Wed Dec 21, 2005 10:34 am
by xnview
Xyzzy wrote:<Moderator's note: This topic has been split from another topic>
Value is immediately updated now, but there is another problem, with slider position update. To reproduce:
Drag slider far left. Click the slider-line below the value field with mouse a few times. Slider is jumping around, and should move to mouse pointer position at first click and stay there for subsequent clicks.
This is the standard behaviour of this control i think...
Posted: Wed Dec 28, 2005 3:59 pm
by Xyzzy
So- Close.
X.
Re: b2: Rotate dialog: slider position position
Posted: Thu Dec 29, 2005 12:28 am
by Dreamer
xnview wrote:Xyzzy wrote:<Moderator's note: This topic has been split from another topic>
Value is immediately updated now, but there is another problem, with slider position update. To reproduce:
Drag slider far left. Click the slider-line below the value field with mouse a few times. Slider is jumping around, and should move to mouse pointer position at first click and stay there for subsequent clicks.
This is the standard behaviour of this control i think...
Me too.
So- Close.
X.
OK, so can I really move it to "Closed.."?
Re: b2: Rotate dialog: slider position position
Posted: Sat Jan 21, 2006 5:32 pm
by helmut
xnview wrote:Xyzzy wrote:<Moderator's note: This topic has been split from another topic>
Value is immediately updated now, but there is another problem, with slider position update. To reproduce:
Drag slider far left. Click the slider-line below the value field with mouse a few times. Slider is jumping around, and should move to mouse pointer position at first click and stay there for subsequent clicks.
This is the standard behaviour of this control i think...
This standard behaviour is really strange, I think. Perhaps there's a setting to programmatic setting to control the "jump width" to change this strange behaviour.