XnView Software

Hi,

is this a FAQ? Searched the forum but couldn't find, sorry if it has been answered.

Is there a setting for the fullscreen view to see just the picture - without the menubar, toolbar, registers, statusbar and even the WinXP taskbar? (Sort of like ACDSee viewer did it?)

Thanks in advance
and best regards

Mark

Hi,

sorry this was misleading:

Is there a setting for the fullscreen view to work without the toolbar etc. directly when doubleclicking on the image in the browser?

Thanks
Mark

PS: meaning switching from F12 shortcut to double click, so both do the same? (Because when using a remote mouse, the PC and keyboard sometimes are further away...)

Mark8 wrote:Hi,

sorry this was misleading:

Is there a setting for the fullscreen view to work without the toolbar etc. directly when doubleclicking on the image in the browser?

Thanks
Mark

PS: meaning switching from F12 shortcut to double click, so both do the same? (Because when using a remote mouse, the PC and keyboard sometimes are further away...)

If you use Fullscreen or F11, you have fullscreen without toolbar...

Hi,

thank you!

Can I set an option that when doubleclicking in the browser it will start fullscreen view instead of the regular view?

(e.g. for presentations, when I only have a remote mouse, not a remote keyboard)?

Best wishes
Mark

Mark8 wrote:Hi,

thank you!

Can I set an option that when doubleclicking in the browser it will start fullscreen view instead of the regular view?

(e.g. for presentations, when I only have a remote mouse, not a remote keyboard)?

Yes, take a look at Genral/Switching mode

Ah there it was - thanks a lot!

Best wishes
Mark