Still cr2 problems with unwanted auto correcting

Discussions on NConvert - the command line tool for image conversion and manipulation

Moderators: XnTriq, xnview

User avatar
helmut
Posts: 8219
Joined: Sun Oct 12, 2003 6:47 pm
Location: Frankfurt, Germany

Post by helmut »

BabaG wrote:my sense (from a non-programmer's point of view, of course), is that something like an auto-correction already exists, such as what is being used in xnview's thumbnail preview frame, and that possibly some code was copied from one place to another that included a call to that routine or function. if that was the case, it would only need to be found and commented out.
Yes, you may be right. I guess it's like this:
Now, auto correction is ON by default. In future, it will be OFF by default and an option is available for turning it ON.
BabaG
Posts: 150
Joined: Sat Mar 03, 2007 6:41 am

Post by BabaG »

that would be even better than commenting it out.
hope this arrives soon!

thanks,
BabaG
BabaG
Posts: 150
Joined: Sat Mar 03, 2007 6:41 am

Post by BabaG »

been another week. thought i'd check in.

any progress on getting an nconvert patch or something for this
issue?

thanks,
BabaG
User avatar
xnview
Author of XnView
Posts: 33840
Joined: Mon Oct 13, 2003 7:31 am
Location: France
Contact:

Post by xnview »

You have an option in the 4.95 release
Pierre.
BabaG
Posts: 150
Joined: Sat Mar 03, 2007 6:41 am

Post by BabaG »

thanks pierre!

two things: is usage of the new option documented anywhere?
edit: found this.

and, when will that be available for linux?

thanks again,
BabaG
Post Reply