XnView Software

Add (to Batch Rename):

- up and down buttons (spin buttons) behind start and step number
- number '1' button behind start and step number (change any number to one)
- ability to change the numbers with a mouse wheel
- ability to change the numbers with up and down arrows (keys)

Thank you!

Dreamer wrote:Add (to Batch Rename):

- up and down buttons (spin buttons) behind start and step number
- number '1' button behind start and step number (change any number to one)
- ability to change the numbers with a mouse wheel
- ability to change the numbers with up and down arrows (keys)

Ok, i'll add it

Dreamer wrote:Add (to Batch Rename):

- up and down buttons (spin buttons) behind start and step number
- number '1' button behind start and step number (change any number to one)
- ability to change the numbers with a mouse wheel
- ability to change the numbers with up and down arrows (keys)

I think you're suggestions are good. But I really don't want a number '1' button. Spin buttons are GUI standard, but I've never seen a 'Reset to 1' button. I think that this will make the user interface messy and rather confuse people than help.

helmut wrote:

Dreamer wrote:Add (to Batch Rename):

- up and down buttons (spin buttons) behind start and step number
- number '1' button behind start and step number (change any number to one)
- ability to change the numbers with a mouse wheel
- ability to change the numbers with up and down arrows (keys)

I think you're suggestions are good. But I really don't want a number '1' button. Spin buttons are GUI standard, but I've never seen a button 'Reset to 1' button. I think that this will make the user interface messy and rather confuse people than help.

Agree for the '1' button

xnview wrote:Ok, i'll add it

Thanks.

xnview wrote:Agree for the '1' button

OK, I just thought it would be useful... Often I need to rename a large number to 1.

Added in 1.80 - '1' button is not really important.