XnView Software

I need help binding a key to launch this program.

"C:\WINDOWS\system32\sndvol32.exe /R"

I know the command is 1014. I just cant figure out how to get it to work. In the past I've set up 5 other binds for xnview and windows.

Try this:

Command:

C:\WINDOWS\system32\sndvol32.exe

Parameters:

/R

Not working. What should the Command be? Command to active window?

What exactly do you need? To show the "Recording Control" window? If so, then it's working here, on Windows XP, what is your OS?

As I said, use this as command:

C:\WINDOWS\system32\sndvol32.exe

and this as parameters:

/R

...just paste the blue text to those fields.

Can I set up a toggle (or single bind) to select between 'microphone' and 'what you hear' in the recording panel?

I notice the command is 1000 for mic and 3000 for 'what you hear'.

So what goes in the fields? And can I have it done in the background silently?

Command:
C:\WINDOWS\system32\sndvol32.exe

Params:
/r 3000

Thats what ive tried so far that isnt working. How can i make it select 'what you hear'?

-----------------------------------------------------------

I found some sites explaining the switches a little bit. /d is the one that specifices the device ID (like wave, what u hear, line-in). But I cant get it to work.

e.g., SndVol32.exe [-R | -D "wave"]

Info on command line switches 1
Info on command line switches 2

I don't know if this is possible, try to contact the HotkeyP author via email.