XnView Software

Posted: **Wed Oct 12, 2011 5:56 pm**

In "Options > View > Fullscreen > Show Information" you can set the display in fullscreen.

I want to display the fields in a single line with pipes as separator, so I entered

Code: Select all

<Filename>    |    <Exposure Time> s    |     f<F-Number>    |    ISO <ISO Value>

This displays correctly right after checking the changes in fullscreen mode, but when you close and reopen Xnews the pipes are replaced by an invisible character (in the configuration textarea) and in fullscreen display the data shows up in separate lines.
Using 1.98.2, Win7x64

Posted: **Thu Oct 20, 2011 11:10 am**

Is anyone else seeing this or is this a local problem on my system?

Posted: **Mon Oct 24, 2011 12:14 pm**

A known issue

Posted: **Mon Oct 24, 2011 5:27 pm**

...now that you said it I searched again and found an old thread from 2006 where something like this is mentioned.
Seems not easy to fix, so I switched to the symbol that was suggested in that thread (Alt+0166) which is ok for me.

XnView Software

Pipe character can't be used in information display

Pipe character can't be used in information display

Re: Pipe character can't be used in information display

Re: Pipe character can't be used in information display

Re: Pipe character can't be used in information display