Page 1 of 1
Conversion from DWG, DXF
Posted: Sun Oct 16, 2016 9:42 am
by jkalousek
Hi, I have simple question really. Compatibility list of XnConvert containts "AutoCAD DWG - dwg, dwt" but when I drag DWG file in and chose "Convert" I get error message: "...dwg 0x0x0 : not a picture".
I know that DWG is proprietary format. So is DWG support only available for some older version of the format? Or am I doing something wrong?
Also same thing is happening to me with DXF format.
Thank You.
Re: Conversion from DWG, DXF
Posted: Sun Oct 16, 2016 5:20 pm
by xnview
no sorry, only XnView Classic has a third party plugin (32bits) for DWG/DXF
Re: Conversion from DWG, DXF
Posted: Mon Oct 17, 2016 7:20 am
by jkalousek
Ok, thank you for reply, so is it possible to do DWG, DXF command line batch conversion with XnView Classic Extended and Nconvert?
Re: Conversion from DWG, DXF
Posted: Mon Oct 17, 2016 7:40 am
by xnview
jkalousek wrote:Ok, thank you for reply, so is it possible to do DWG, DXF command line batch conversion with XnView Classic Extended and Nconvert?
with XnView Classic if you have the third party plugin (not free)
Re: Conversion from DWG, DXF
Posted: Mon Oct 17, 2016 7:54 am
by jkalousek
xnview wrote:jkalousek wrote:Ok, thank you for reply, so is it possible to do DWG, DXF command line batch conversion with XnView Classic Extended and Nconvert?
with XnView Classic if you have the third party plugin (not free)
Ok, I noticed that it is in paid version, thats not a problem but I need it to run on Linux so has paid version of XnView MP same capabilities as XnView Classic in regards of formats and batch conversion from command line?
Thank you for information!
Re: Conversion from DWG, DXF
Posted: Mon Oct 17, 2016 12:00 pm
by xnview
the plugin exists only for windows