XnView Software

Hello,

I use XnViewMP 0.86 on a Win7 System.

The panel IPTC-IIM/XMP -> Date/Time reads the date value for "Created date/time" correctly from metadata stored inside an image file.
But the time value is always set to 00:00. See attached screenshot.

This is very annoying because in case of only modifying one value and not taking care of date/time, time is reset to 00:00.

On the other hand it would be very helpful to allow also to enter seconds to the time value.

Best regards
Herb

could you send me a test file?

Hello Pierre,

thanks for your investigations.
Image is sent via mail, because of size.

Best regards
Herb

will be fixed in next version

Hello Pierre,

thanks for the correction.
But please allow an additional comment: I looked again into the IPTC (and also XMP) standard and have seen that both request also a timezone value for time tags.
It would be wonderful if that would also be possible.

Best regards
Herb

ok, but please make a post in suggestion