Page 1 of 1
B1: Batch Convert: Close dialog after conversion
Posted: Tue Dec 13, 2005 9:32 pm
by helmut
After Batch conversion, some people want the "Batch Convert" dialog to close, others want to keep it open.
Perhaps a good way to serve both needs is a checkbox
[x] Close dialog after conversion
Ho, yes!
Posted: Tue Dec 13, 2005 9:43 pm
by Clo
• Hi !
- I agree and support this !
- That bores me for years…
- Maybe only a hidden INI entry could do the trick too, and should cause a smaller work to add ? Anyway, the entry shall exist for the option…
Posted: Wed Dec 14, 2005 12:08 am
by Dreamer
I support this request too.
Posted: Mon Dec 19, 2005 11:02 pm
by Dreamer
Added, but maybe a dialog (below) would be better:
Code: Select all
[ "Close dialog after conversion" ]
[ (o) Yes ( ) No ]
[ [x] Do not show this dialog again ]
Whole Batch Convert dialog would be clearer I think.
This option could be added also to main Options.
What do you think?
Posted: Tue Dec 20, 2005 2:54 pm
by xnview
Dreamer wrote:Added, but maybe a dialog (below) would be better:
Code: Select all
[ "Close dialog after conversion" ]
[ (o) Yes ( ) No ]
[ [x] Do not show this dialog again ]
Whole Batch Convert dialog would be clearer I think.
This option could be added also to main Options.
What do you think?
I think that only "close dialog..." is better and clear
Posted: Fri Jan 06, 2006 1:52 pm
by Xyzzy
In b3 there's checkbox Close dialog after conversion that works, so I consider this Solved.
X.