XnView Software

XnViewMP 1.4.5 64bit
Windows11 (22H2), display resolution 3840x2160, win scaling 150%

Batch convert
minor UI adjustments

• move 'Use multiple CPU Cores' from Output to Settings tab

• move 'Beep at the end of process' from Settings to Output tab (to 'After conversion' group)
  OR
  move whole 'After conversion' group from Output to Settings tab, as Output is about destination/filename/format, but not bout what happens after

• realign controls on Settings tab to the top as there is some regression

Related

• suggestions
  Batch convert - actions - remember expanded/collapsed state
  Batch convert - actions - reinforce consistency of ranges ui
  Batch convert - input - Hot folders manager - minor improvements
  Batch convert - output - improve information readability
  Batch convert - ui - remove tabs
  - postponed -
  Batch convert - input - normalize use of modifier keys
  - done -
  Batch convert - move controls between Output and Settings (current post)

user0 wrote: Fri May 12, 2023 6:41 pm

• move 'Use multiple CPU Cores' from Output to Settings tab

Not sure

• move 'Beep at the end of process' from Settings to Output tab (to 'After conversion' group)
  • realign controls on Settings tab to the top as there is some regression

See issue for current status and some details.

This problem is supposed to be fixed in XnView MP 1.5.0 beta. Please check and confirm the bug fix here.

done in 1.5.0

xnview wrote: Tue May 16, 2023 3:35 pm

user0 wrote: Fri May 12, 2023 6:41 pm

• move 'Use multiple CPU Cores' from Output to Settings tab

Not sure

if its "core per file" and not "coreS per file" - it has some sense to keep this setting in Output tab,
but to my taste Output tab shall be only about "what(filename/format)/where(folder/etc..)", not "how", especially if there is Settings tab