Page 1 of 1
Scaling by width or height alone is not supported
Posted: Mon Mar 17, 2025 9:24 am
by Cople
It is supported in XnConvert, but the exported NConvert command does not achieve the same effect; NConvert only supports setting width and height at the same time.
Re: Scaling by width or height alone is not supported
Posted: Wed Mar 19, 2025 4:16 pm
by xnview
yes you use 0
Re: Scaling by width or height alone is not supported
Posted: Tue Mar 25, 2025 3:23 am
by Cople
xnview wrote: Wed Mar 19, 2025 4:16 pmyes you use 0
thanks. it should be added to the help documentation