Scaling by width or height alone is not supported

Cople · Post by **Cople** » Mon Mar 17, 2025 9:24 am

It is supported in XnConvert, but the exported NConvert command does not achieve the same effect; NConvert only supports setting width and height at the same time.

Post by **xnview** » Wed Mar 19, 2025 4:16 pm

yes you use 0

Cople · Post by **Cople** » Tue Mar 25, 2025 3:23 am

xnview wrote: Wed Mar 19, 2025 4:16 pmyes you use 0

thanks. it should be added to the help documentation

XnView Software

Scaling by width or height alone is not supported

Scaling by width or height alone is not supported

Re: Scaling by width or height alone is not supported

Re: Scaling by width or height alone is not supported