XnView Software

Posted: **Sat Sep 09, 2006 10:50 am**

When using selection, one can easily swap the orientation of the selection by pressing the Tab key (or choosing Edit > Selection - Swap width & height).

When reloading a user-defined selection size the selection is restored properly, but swapping width & height is not possible. I think swapping width & height should be always possible.

XnView 1.82.4

Posted: **Mon Sep 11, 2006 7:17 am**

helmut wrote:When using selection, one can easily swap the orientation of the selection by pressing the Tab key (or choosing Edit > Selection - Swap width & height).

When reloading a user-defined selection size the selection is restored properly, but swapping width & height is not possible. I think swapping width & height should be always possible.

XnView 1.82.4

Yes, right

Posted: **Sun Nov 19, 2006 6:52 pm**

From what I can see this is fixed in 1.90 Beta 1. --> Closed

XnView Software

Orientation of User defined selection not changeable

Orientation of User defined selection not changeable

Re: Orientation of User defined selection not changeable