Page 1 of 1
Batch editing - order of commands unchangeable?
Posted: Sat Jul 31, 2004 1:35 pm
by henrik2000
Hi. When batch editing, i collect several commands like "file size" and "sharpen". But i cannot change the order of the collected commands? I have to remove the commands and add them again in my desired order? (For example, you wouldn't want sharpening before resizing.) Thanks!
Posted: Sat Jul 31, 2004 10:29 pm
by Anika
I want to support this request. I have recognized the same problem.
Posted: Sun Aug 01, 2004 1:19 pm
by Dreamer
Me too, not so important for me, but some up & down butons or drag & drop would be nice
Re: Batch editing - order of commands unchangeable?
Posted: Mon Aug 02, 2004 11:51 am
by xnview
henrik2000 wrote:Hi. When batch editing, i collect several commands like "file size" and "sharpen". But i cannot change the order of the collected commands? I have to remove the commands and add them again in my desired order? (For example, you wouldn't want sharpening before resizing.) Thanks!
Ok, i'll add this feature.
Pierre.
Posted: Fri Sep 03, 2004 8:56 pm
by helmut
Dreamer wrote:Me too, not so important for me, but some up & down butons or drag & drop would be nice
Up/Down buttons for reordering the transformations will be available in XnView 1.71 (next release, possibly in October).
(Just to water your mouth a bit)