Batch editing - order of commands unchangeable?

henrik2000 · Post by **henrik2000** » Sat Jul 31, 2004 1:35 pm

Hi. When batch editing, i collect several commands like "file size" and "sharpen". But i cannot change the order of the collected commands? I have to remove the commands and add them again in my desired order? (For example, you wouldn't want sharpening before resizing.) Thanks!

Anika · Post by **Anika** » Sat Jul 31, 2004 10:29 pm

I want to support this request. I have recognized the same problem.

Dreamer · Post by **Dreamer** » Sun Aug 01, 2004 1:19 pm

Me too, not so important for me, but some up & down butons or drag & drop would be nice

Post by **xnview** » Mon Aug 02, 2004 11:51 am

henrik2000 wrote:Hi. When batch editing, i collect several commands like "file size" and "sharpen". But i cannot change the order of the collected commands? I have to remove the commands and add them again in my desired order? (For example, you wouldn't want sharpening before resizing.) Thanks!

Ok, i'll add this feature.
Pierre.

helmut · Post by **helmut** » Fri Sep 03, 2004 8:56 pm

Dreamer wrote:Me too, not so important for me, but some up & down butons or drag & drop would be nice

Up/Down buttons for reordering the transformations will be available in XnView 1.71 (next release, possibly in October).

(Just to water your mouth a bit)

XnView Software

Batch editing - order of commands unchangeable?

Batch editing - order of commands unchangeable?

Re: Batch editing - order of commands unchangeable?