RC4: "Move" cursor not reset to standard cursor

helmut · Post by **helmut** » Thu Jun 02, 2005 7:55 pm

When selecting an area, and then moving inside the selected area and pressing Ctrl key, the mouse cursor changes and indicates that selection can be moved. This is good, but when releasing Ctrl key, the mouse cursor is not reset. (Minor issue).

Olive · Post by **Olive** » Thu Jun 02, 2005 11:14 pm

yes, need to move the mouse to reset it.
though it's properly reset if LMB is set to move selection (in options>keyboard/mouse)

Dreamer · Post by **Dreamer** » Fri Jun 03, 2005 2:21 pm

Confirmed.

ckit · Post by **ckit** » Mon Jun 13, 2005 10:46 am

Confirmed in RC6 - minor issue until you move the mouse.

Hacker · Post by **Hacker** » Mon Jun 13, 2005 10:57 am

ckit wrote:Confirmed in RC6 - minor issue until you move the mouse.

? The cursor isn't shown after moving the mouse, either.
1. Open file in View
2. Go to normal Fullscreen
3. Wait for cursor to disappear
4. Press F12 and try to click something.

Roman

ckit · Post by **ckit** » Mon Jun 13, 2005 11:00 am

Hacker wrote: ? The cursor isn't shown after moving the mouse, either.
1. Open file in View
2. Go to normal Fullscreen
3. Wait for cursor to disappear
4. Press F12 and try to click something.

Roman

This has been fixed in RC7.

ckit · Post by **ckit** » Tue Jun 14, 2005 6:40 am

helmut wrote:When selecting an area, and then moving inside the selected area and pressing Ctrl key, the mouse cursor changes and indicates that selection can be moved. This is good, but when releasing Ctrl key, the mouse cursor is not reset. (Minor issue).

This is still a minor issue in RC7.

XnView Software

RC4: "Move" cursor not reset to standard cursor

RC4: "Move" cursor not reset to standard cursor

Re: RC4: "Move" cursor not reset to standard curso