Broken multipage convert?

[flatleyld]

Something must be up with my install then. I've tried the same settings as you and it still fails. I'll try to uninstall and reinstall or try a portable version.

[flatleyld]

I've been testing some more and found that if I change the "When output files already exist" value to rename instead of replace, the conversion works on all pages. That's not good because I need to replace files in a whole lot of directories, not make duplicates of them.

[cday]

I've been testing some more and found that if I change the "When output files already exist" value to rename instead of replace, the conversion works on all pages. That's not good because I need to replace files in a whole lot of directories, not make duplicates of them.

At a quick look, hopefully not too quick, I don't have a problem with 'Replace' either:

Image_1.png

Image_2.png

The resulting multipage TIFF opens and views normally...

[flatleyld]

I'm trying to start from scratch, but XnConvert is storing settings somewhere. Every version I try is holding all of the settings I previously. How do I clear that out and start fresh? I've checked the registry and found nothing.

[flatleyld]

I've tried this on another computer with the same results.

[cday]

Do you have the problem even with a simple 'Rotate' action, which is how I'm testing?

I can only suggest that you upload screenshots of your tabs, at least the Input, Output, Status and Settings tabs, although I don't have any ideas about what might be causing the problem.

[flatleyld]

Yes, I get the same error on a rotate. If I get some time I'll upload screenshots, but they're no different than what I've described.

[xnview]

please send me your multipage tiff?

[cday]

please send me your multipage tiff?

It's posted above...

[xnview]

please send me your multipage tiff?

It's posted above...

where???

[cday]

please send me your multipage tiff?

It's posted above...

where???

Here

Yes, it's along thread now...

[xnview]

Yes, it's along thread now...

houps, thanks

so no problem here too.

[flatleyld]

I wonder what the crap is wrong with my install then? Is there a way to clear out all settings and existence of xnconvert and try again?

[cday]

I wonder what the crap is wrong with my install then? Is there a way to clear out all settings and existence of xnconvert and try again?

I don't see it as a problem with your install, although I might be wrong, and in any case you reported the same result on another computer, rather as resulting from a setting you're using, although it is hard to think what could cause the results you are seeing.

I would again suggest uploading screenshots of your tabs mentioned above...