"Invert" selection option

klumy · Post by **klumy** » Fri Oct 07, 2005 5:59 pm

an option to invert the rectangle selection would be great

Post by **xnview** » Sat Oct 08, 2005 10:39 am

klumy wrote:an option to invert the rectangle selection would be great

Why, you can only make rectangle for selection?

klumy · Post by **klumy** » Sat Oct 08, 2005 11:04 am

I am looking for an INVERT option

so I can select the area OUTSIDE from the rectangle

helmut · Post by **helmut** » Sat Oct 08, 2005 10:06 pm

klumy wrote:I am looking for an INVERT option

so I can select the area OUTSIDE from the rectangle

At the moment, XnView supports only rectangular selections. This is why you cannot invert selections in XnView (inverting a rectangle makes a rectangle with a whole in it).

XnView Software

"Invert" selection option

"Invert" selection option

Re: "Invert" selection option