b1: 'Replace # by' wrong data used.

marsh · Post by **marsh** » Sun Dec 11, 2005 6:36 pm

In the new batch rename> duplicate... dialog, the data sets for numbers/characters radio buttons are reversed. Characters are using numbers data. Numbers are using chararcters data.

helmut · Post by **helmut** » Sun Dec 11, 2005 6:43 pm

marsh wrote:In the new batch rename> duplicate... dialog, the data sets for numbers/characters radio buttons are reversed. Characters are using numbers data. Numbers are using chararcters data.

Well spotted - I confirm.

Post by **xnview** » Mon Dec 12, 2005 7:49 am

helmut wrote:
marsh wrote:In the new batch rename> duplicate... dialog, the data sets for numbers/characters radio buttons are reversed. Characters are using numbers data. Numbers are using chararcters data.
Well spotted - I confirm.

Confirmed

marsh · Post by **marsh** » Tue Dec 20, 2005 1:08 am

Fixed in beta2

Xyzzy · Post by **Xyzzy** » Tue Dec 20, 2005 8:49 am

Let me ask again- and what is this Duplicate option going to do? I played with it a bit and cannot figure it out...

X.

marsh · Post by **marsh** » Tue Dec 20, 2005 9:30 am

Xyzzy wrote:Let me ask again- and what is this Duplicate option going to do? I played with it a bit and cannot figure it out...

X.

If a duplicate name is produced when using main template, this dialog decides what to do with that by using a second template. It also adds the capacity of using alphabet characters instead of numbers. There is a topic about this in alpha section, also.

XnView Software

b1: 'Replace # by' wrong data used.

b1: 'Replace # by' wrong data used.

Re: b1: 'Replace # by' wrong data used.

Re: b1: 'Replace # by' wrong data used.