Option to preserve position when converting PSD layers

[jkm]

Since layers in Photoshop documents can have different dimensions and different origin points (positions), it would be beneficial if Batch Convert were enhanced to be able to preserve the position of the individual layers when converting the layers of a PSD.

This could be done with one additional option in the "Canvas Resize" action.

Add the following option to the "Position" menu:
"Original Position"


So if you have a PSD document with a 500x500 canvas size, but it contains a layer with dimensions 200x200, located @ 217,124 then the canvas resize action could specify a width, height of 500x500, and with the Position "Original Position" selected, the 200x200 layer would be padded as: left 217, above 124, right 83, below 376.

Different layers would be padded differently to preserver their origin points.

This ability to preserve the position of individual layers is a capability built into Photoshop, so it would be nice if this wasn't lost when converting with XnViewMP.