When using XnView 1.91.1 on top of WinXP, I've on two occasions got a crash in the Batch Convert Dialog when adjusting Sharpen value in the Transformations tab. In this case the Sharpen item was at the end of the active list and I was just clicking on the left/right arrow buttons.
DrWatson reported an access violation on EIP 0x4ffef8.
Crash in Batch Convert dialog
Moderator: xnview
-
ckit
- XnThusiast
- Posts: 2586
- Joined: Tue Feb 17, 2004 1:11 am
- Location: QLD, Australia
-
aguirRe
- Posts: 6
- Joined: Sat May 12, 2007 8:17 am
Yes, I did that too to re-arrange filter order before.
I've also had a lot of problems making the settings stick in this dialog. Sometimes after changing a value on one item and switching with the mouse to another item and then back again, the value is restored so I have to change it again.
Especially the Resize item has this issue, but others as well
I've also had a lot of problems making the settings stick in this dialog. Sometimes after changing a value on one item and switching with the mouse to another item and then back again, the value is restored so I have to change it again.
Especially the Resize item has this issue, but others as well
-
xnview
- Author of XnView
- Posts: 47539
- Joined: Mon Oct 13, 2003 7:31 am
- Location: France
-
aguirRe
- Posts: 6
- Joined: Sat May 12, 2007 8:17 am
-
xnview
- Author of XnView
- Posts: 47539
- Joined: Mon Oct 13, 2003 7:31 am
- Location: France
Ok, i have perhaps found the problem, could you send me your email by PM (i would like to send a test version?)aguirRe wrote:No, but it happens pretty frequently, so it should be easy to reproduce. Otherwise you have the EIP above and I can also send you the DrWatson crash info if you need it.
Pierre.