Slide show from command line

[9Mark9]

Version 1.80.1 ...

I have a file show.sld that contains the following lines:

# Slide Show Sequence
"F:\img1.jpg"
"F:\img2.jpg"
"F:\img3.jpg"
"F:\img4.jpg"

The parameters for timer, effects, etc. are purposely left out because I´d like to use the parameters stored in the xnview.ini file.

The command line syntax:

e:\programs\imaging\xnview\xnview.exe -slide "e:\show.sld"

The slide show starts but it doesn't use the parameters defined in xnview.ini.

Any suggestions? Thanks!

[xnview]

Version 1.80.1 ...

I have a file show.sld that contains the following lines:

# Slide Show Sequence
"F:\img1.jpg"
"F:\img2.jpg"
"F:\img3.jpg"
"F:\img4.jpg"

The parameters for timer, effects, etc. are purposely left out because I´d like to use the parameters stored in the xnview.ini file.

The command line syntax:

e:\programs\imaging\xnview\xnview.exe -slide "e:\show.sld"

The slide show starts but it doesn't use the parameters defined in xnview.ini.

Any suggestions? Thanks!

Right a bug if some settings are missing in the sld file...