Print / "Single Custom"

Peter2 · Post by **Peter2** » Mon Jun 23, 2008 10:41 am

I have a B/W TIFF, 20.87x29.65cm (A4, Portrait). My printer settings are A4-portrait.

My units are "cm", NO option "Maintain aspect ratio"

Command "Print" - Layout - "Single-Custom"

I activate "Automatic rotate" and enter "Width 21, Height 29.7" -> the preview is rotated 90° ???.

I disable automatic rotate -> the preview is OK..

I change Width/height -> OK witout Rotating. Not OK with Rotating

Seem to be a problem in connection "Rotate / Mainatin aspect ratio".?

Command "Print" - Layout - "Single-Scale"
I use X = 1.2, Y = 0.3, rotate automatic -> but there is no rotation (where I think it should be ...)

Command "Print" - Layout - "Single-Scale"
If I set "X=100" and "Y=100", it scales "only" to "max. fit on page" (Scale 1.1), but in the edit box is displayed "100 / 100". It should display the real scale-value.
Peter

Peter2 · Post by **Peter2** » Wed Jun 25, 2008 8:06 pm

Can someone confirm - or disagree with - these problems?

Peter

Peter2 · Post by **Peter2** » Fri Jul 04, 2008 4:32 pm

Hello

push up again ...

Peter

Post by **xnview** » Tue Jul 15, 2008 12:31 pm

i'll check