batch processing canon raw cr2 files

[BabaG]

just had to abandon the batch processing of cr2 files on something because
the results didn't match the input parameters at all. not even close.

all i was doing was crop, levels, save to tga format in a separate folder.
i used xnview crop tool to determine x/y positioning. when i put those
numbers into the crop parameters in the batch tool i got something which
did not match my positioning at all. (v1.96)

i had recently done the same thing with jpg to jpg processing and it worked
fine so it would appear that this might be specific to cr2 files. bummer.

thanks,
BabaG

[marsh]

Mismatched settings can produce a different result when comparing converter to viewer. With General>Read/Write>Read>Camera RAW [x]High resolution setting and View>Misc>Camera RAW>Full size, I had identical results for x:512 y:512 W:512 H:512 crop. Output was png.

[BabaG]

that seems to have been it. thanks a lot!

BabaG