1.98: Open With not passing all filenames

ttfn · Post by **ttfn** » Fri May 13, 2011 3:39 pm

I have a windows batch file setup under Open With. In 1.98 if I activate it after selecting a large number of files only the first ten are passed to it.

In 197.8 XnView passed as many files from the selection as it could fit onto the command line

Andrzej · Post by **Andrzej** » Sat May 14, 2011 7:09 am

I have same problem : after command Open with ... Photoshop open only 10 pictures...

Post by **xnview** » Mon May 16, 2011 6:47 am

Right, i have changed that in 1.98

i'll fix it

Andrzej · Post by **Andrzej** » Sat Jul 02, 2011 5:10 pm

Now - with 1.98.1 - i can open only 20 files... In 1.97 was"t limit.

Post by **xnview** » Mon Jul 04, 2011 6:32 am

Andrzej wrote:Now - with 1.98.1 - i can open only 20 files... In 1.97 was"t limit.

Do you have a OpenWithMax in your .ini?

Andrzej · Post by **Andrzej** » Mon Jul 04, 2011 7:02 am

No, I have'nt

Post by **xnview** » Mon Jul 04, 2011 7:25 am

Andrzej wrote:No, I have'nt

And if you add in [Start] section, OpenWithMax =100?

Andrzej · Post by **Andrzej** » Mon Jul 04, 2011 9:06 am

It's working, all is OK, thanks

XnView Software

1.98: Open With not passing all filenames

1.98: Open With not passing all filenames

Re: 1.98: Open With not passing all filenames

Re: 1.98: Open With not passing all filenames

Re: 1.98: Open With not passing all filenames

Re: 1.98: Open With not passing all filenames

Re: 1.98: Open With not passing all filenames

Re: 1.98: Open With not passing all filenames

Re: 1.98: Open With not passing all filenames