Error when zooming into a photo in Preview Area [Solved]

*** Please report new bugs here! ***

Moderators: helmut, XnTriq, xnview, Dreamer

User avatar
xnview
Author of XnView
Posts: 46236
Joined: Mon Oct 13, 2003 7:31 am
Location: France
Contact:

Re: Error when zooming into a photo in Preview Area [Solved]

Post by xnview »

LuNik wrote: Mon Sep 19, 2022 4:59 pm
  • "Zoom-out", "Zoom-in" and "Zoom-out& Zoom-in"
    at 142% only a little part of the photo is visible any more, looks like the photo is shifted to the upper left corner. From 200% to 1600%
    it works normal again. In some (rare) cases the effect starts when zooming at 200%. Perhaps depending on the position of the mouse pointer???
but with 'bilinear', you have not the problem right?
Pierre.
LuNik
Posts: 38
Joined: Thu Aug 04, 2022 8:24 am

Re: Error when zooming into a photo in Preview Area

Post by LuNik »

I can confirm that! Looks like it works with "bilinear" with all modes ("Never", "Zoom-out", "Zoom-in" and "Zoom-out& Zoom-in")!
LuNik
Posts: 38
Joined: Thu Aug 04, 2022 8:24 am

Re: Error when zooming into a photo in Preview Area

Post by LuNik »

Bonjour Pierre,
you also asked for the setting of "Camera Raw". My standard setting is "embedded preview". zecanard has reported a problem that is very likely the same. Despite to him I have no problems when I use "Full size" or "Half size" for "Camera Raw"!!!!

Bon weekend
Ludger
User avatar
xnview
Author of XnView
Posts: 46236
Joined: Mon Oct 13, 2003 7:31 am
Location: France
Contact:

Re: Error when zooming into a photo in Preview Area

Post by xnview »

LuNik wrote: Wed Sep 21, 2022 2:08 pm I can confirm that! Looks like it works with "bilinear" with all modes ("Never", "Zoom-out", "Zoom-in" and "Zoom-out& Zoom-in")!
do you have always the problem?
Pierre.
LuNik
Posts: 38
Joined: Thu Aug 04, 2022 8:24 am

Re: Error when zooming into a photo in Preview Area

Post by LuNik »

Hi,
thx for your reply. The problems occured more than a year ago. Using newer version of XnView MP I didn't run into that bug.
So this can be looked upon as solved!

Nevertheless thanks for your support!!!

Ludger
Post Reply